Versions Compared

Old Version 5

changes.mady.by.user Unknown User (nike.olabiyi)

Saved on

compared with

New Version Current

changes.mady.by.user Unknown User (nike.olabiyi)

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Published by Scroll Versions from space CDZP and version 1.1.1.0

...

  1. Can occasionally occur when writing firmware or reading / writing parameters. Either reconnect the sensor or restart the application.
  2. If this occurs every time then it is most likely to do with having wrong DFU driver installed. The program is then unable to connect to the (DFU) device in configuration mode and will therefore display the error message above. Please follow the instructions under STM32Bootloader Driver section on the Getting Started page to resolve this.

Failed to write firmware or sensor does not show up.

...

  • Check that all connectors are plugged in correctly.
  • Make sure the correct driver is installed, please follow the instructions under STM32Bootloader Driver section on the Getting Started page.
  • Try another USB port, preferably connected directly with the computer without any hub or docking station between.
  • Unplug the sensor, press and hold the black button on the interface board while plugging the sensor back in. It should now show up as "Device In Configuration Mode" and be possible to write a new firmware to it.