- Connect the FPC cable to the interface board:
- Lift the flip lock on the interface board.
Insert the FPC cable into the end of the connector, with the connector pads facing down, towards interface board. The yellow piece of PCB of the connector on the other side of the cable is facing upwards. Make sure the direction is straight into the connector and the pads have reached the end of the connector.
Make sure the connector pads of the FPC cable are facing downwards, towards interface board. The sensor risks damage if the FPC cable is connected in wrong direction.
Press down the flip lock.
- Connect the FPC cable to the sensor:
- Place the sensor so that the sensor connector pads of the sensor are facing downwards (steel surface upwards).
- Insert sensor into the connector on FPC cable (yellow piece of PCB of the FPC connector still facing upwards).
- Make sure the direction of the pads is straight into the connector, and the pads have reached the end of the connector.
- To use Neonode Workbench, USB HID Digitizer mode, USB HID Raw mode, or SDK: Connect a USB cable with a Micro USB type B connector to the interface board.
- To use I2C Transport: Wire the pads of +5V, DR-B0, I2C-D, I2C-C, and GND on the interface board to the host system. For details, refer to Electrical Integration. Do not connect power until the following steps have been performed.
Place the sensor on a table with the steel surface facing downwards and with the optical surface facing towards you.
Make sure no object is within the touch active area of the sensor before connecting power to the sensor through USB or I2C. The sensor calibrates itself when powered on and an object within the touch active area may interfere with the calibration.
To use Neonode Workbench, USB HID Digitizer mode, USB HID Raw mode, or SDK: Insert the USB cable into a computer meeting the requirements of USB HID or SDK, respectively.
- To use I2C Transport: Connect the power to the sensor through the I2C.
- The green LED on the interface board lights up when connected.