Contents of Release

• Bugfix release for zForce Programmer 1.1.0.0

Main Features

• No new features

Bug fixes

• Some scanning range values were mistakenly disabled by zForce Programmer. All scanning ranges supported by the TSM (Touch sensor Module) are enabled in this release of zForceProgrammer.

Known Issues

• Reading and writing parameters does not work before leaving DFU/Config mode in the following cases:

  • After updating DFU drivers.

  • After starting zForce Programmer with a sensor plugged in that is already in DFU/Config mode.

  • After plugging in a sensor, while holding down the DFU button on the interface board.

• The CLI application should support the --overwrite flag, but it gives an error message. The shorthand, -o, however, works.