Contents of Release
- First release of zForce Programmer 1.1.0.0
Main Features
- Full support for NTSMF 2.2
- Backwards compatibility with NTSMF 2.0, 2.1.
CLI Support
Visualizer
Bug fixes and performance.
Rename of min/max touch active area parameters
Additional persistent parameters
- If the wrong DFU driver is detected, you can now install the correct one for the running sensor from inside zForceProgrammer. Requires Administration privileges.
Known Issues
Reading and writing parameters does not work before leaving DFU/Config mode in the following cases:
After updating DFU drivers.
After starting zForceProgrammer with a sensor plugged in that is already in DFU/Config mode.
After plugging in a sensor, while holding down the DFU button on the interface board.