Contents of Release
- Bugfix release for zForce Programmer 1.1.0.0
Main Features
- No new features
Bug fixes
- Some scanning range values were mistakenly disabled by zForce Programmer. All scanning ranges supported by the TSM (Touch sensor Module) are enabled in this release of zForceProgrammer.
Known Issues
Reading and writing parameters does not work before leaving DFU/Config mode in the following cases:
After updating DFU drivers.
After starting zForce Programmer with a sensor plugged in that is already in DFU/Config mode.
After plugging in a sensor, while holding down the DFU button on the interface board.
- The CLI application should support the --overwrite flag, but it gives an error message. The shorthand, -o, however, works.