Using the Neonode Workbench tool (or any other software that uses ASN.1 for configuration) the configuration can be changed in runtime. This runtime configuration can not be saved to theTouch Sensor Module permanently. TheTouch Sensor Modulewill always use the default configuration after reboot and after flashing a new firmware.
Using the Neonode Workbench tool (or any other software that uses ASN.1 for configuration) the configuration can be changed in runtime. This runtime configuration can not be saved to theTouch Sensor Module permanently. TheTouch Sensor Modulewill always use the default configuration after reboot and after being re-flashed.
Using the zForce Programmer tool, the configuration can be stored persistently.
Note however that the default configuration is always restored after flashing a new firmware.
Communication
ASN.1 protocol version
1.9
1.11
HID
Yes
Yes
I2C
Yes
Yes
Functionality
Persistent Parameters
No
Yes, possible when using the zForce Programmer tool.
Multi finger support (up to ten fingers).
Yes
Yes
Click On Touch
Yes
Yes
Floating Protection
Yes
Yes
Reflective edge
Yes
Yes
Utilization of max possible TAA
101
115
122
158
180
209
230
295 – Extended range firmware
310 - Extended range firmware
346 - Extended range firmware
374 - Extended range firmware
101
115
122
158 – From production date 14th of April 2021
180
209
230
295
310
346
Flip X/Y
Yes
Yes
Merge touches
Yes
No. The functionality is removed in FW 2.0 and later.